Timecode simulator

What this feature is for

Display SMPTE timecode during rehearsals and local-network tests. This reference is separate from the show clock.

Where to find it

Open the timecode controls in the Live/Next screen.

Steps

1. Choose a frame rate (24, 25, 29.97 or 30 fps).
2. Use Start (then Stop), Pause and Reset to control the simulation; the digits run continuously as soon as the simulation is started.
3. Adjust speed (0.1× to 8×), offset or seek position if needed.
4. Broadcast on the local network when other stations should follow in read-only mode.

What happens next

Following stations display the sender's timecode; their transport controls are disabled. The show clock separately measures elapsed show time since the start GO, excluding pauses.

Who can take action

The operator controlling the simulator; following stations view it read-only.

Common issues

• Show clock is not zero when idle: reset it.
• A follower cannot start the timecode: control it from the broadcasting station.
• The timecode is displayed but does not advance: check that the simulation is running (the button then shows Stop) and that this station is not following a remote broadcaster.

FAQ

Can timecode fire a cue?

No. Timecode never triggers GO; only an authorized person does so manually.